![how to make a smoking pipe out of a light bulb how to make a smoking pipe out of a light bulb](https://img.wonderhowto.com/img/89/13/63475269861365/0/make-pipe-out-highlighter-marker.1280x600.jpg)
patents to his name, Thomas Edison is considered by many to be Americas greatest inventor, developing several revolutionary devices that changed the world. Use the marker to tighten up the large end of the pipe, then it is completed. Thomas Edison: Prolific Inventor and Cigar Smoker. Next bend the foil at the point where the big end starts to create the pipe shape.
How to make a smoking pipe out of a light bulb how to#
Then he demonstrates how to use the pen to tighten up the foil tube around the pen but leaving the inside hollow. Drill holes in the bottle cap, stick the straws through them, and put the cap on top of the bulb.
![how to make a smoking pipe out of a light bulb how to make a smoking pipe out of a light bulb](https://img.wonderhowto.com/img/22/78/63475291087074/0/make-drug-vaporizer-with-light-bulb.1280x600.jpg)
Cut the end off of the bulb and dispose of the wires inside. As well as the bulb, you'll need 2 straws and a bottle cap. You don't want a bowl with a flat bottom. Next use the marker to roll the foil into a pipe shape. To make your own vaporizer, try using a light bulb. See more ideas about bongs, diy bong, pipes and bongs. If you used a drill bit for the bowl and not a special pipe tool you want to take a Dremel tool and indent the bowl so that there is a dip in the bottom or the bowl. Explore Pipes and Bongs's board 'Diy smoking devices', followed by 7,072 people on Pinterest. Do not suck in unless you want sawdust in your mouth. Make sure the stem chamber and bowl connect by blowing through both sides. Then you would take a small drill bit, about a 2.8 or 2.6 and drill from the bottom corner of the bowl, slightly angled downward into the bottom of the stem chamber. If you are making a straight pipe, you would drill the stem chamber into the bottom corner of the bowl stopping about 1/3in before reaching the bowl. Then get one of the smallest drill bits you have, I used a 1.2 drill bit, and drill from the bottom of the bowl to the stem chamber which should be directly below the bowl. Drill the stem so that it ends under the center of the bowl.(doesn't really matter how far under, just give yourself space to carve and sand out the shape). For the stem I used a 5/16 drill bit because that was the size of the stem insert but again it varies. There are specific tools for drilling out the bowl, but seeing as pipe making websites aren't so user friendly and I don't like waiting for things to ship I used a 3/4 drill bit for the bowl(the size of bowl varies by taste and style).